Kohler K-1913-R-96 Instalační příručka stáhnout pdf (Strana 29)

17. Conﬁrm Operation and Check for Leaks

All Installations

This bath is designed to contain water, but small amounts of water will escape during normal operation.

When the bath is functioning properly, you may see:

Water along the access panel or in the drip tray, particularly after the seal deﬂates.

Water coming out of the accumulator drain tube and entering the drip tray and drip tray

drain.

Some water going over the door seal and entering the drip tray when the bather moves

abruptly in a bath completely ﬁlled to the overﬂow.

A small amount of water dripping from the bottom of the door. This happens when water

that runs over the top of the door seal enters the gap between the primary and secondary

seals. The water follows the path to the lowest point and may drip into the drip tray there

until the water level stabilizes.

WARNING: Risk of electric shock. Connect the controller to a properly grounded, grounding-type

receptacle protected by Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device (RCD).

Do not remove the plug grounding pins. Do not use grounding adapters.

Connect the controller power cord to a 120 V GFCI or RCD protected outlet and turn on the main

power supply. If a UPS has been installed, connect the power following the directions supplied with

the UPS.

NOTE: If any of the actions below fail to occur, consult the ″Troubleshooting Procedures″ section of this

guide.

Drip Tray

Drain

Secondary Drain Valve

Bath Drain

Accumulator Valve

and Drainage Line

Kohler Co. 29 1128532-2-C

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 135 136

Žádné komentáře

Kohler K-1913-R-96 Instalační příručka Strana 29